Electronics

Drill depth show with gyro sensor – Open Electronics


By Bianchi Gabriele on September 22, 2022

Most bench drills have a ruler to learn the drilling depth. The higher the accuracy at which the specified place will be learn, the higher the success of the job. On this venture we see another proposal: a show through which we see the drilling depth because of a gyroscopic sensor and an 8-digit 7-segment show with Arduino Nano assist.

 

However how is the depth of drilling measured? There are a number of prospects for a size measurement. An ultrasonic measurement might work, a wire encoder and a rotary encoder are additionally choices, right here we see another answer.

Most drills have a facet handwheel to regulate the depth which will be turned approx. 270 °. So not even a full flip, you possibly can then measure the angle with a gyro sensor. The cable connection can’t be twisted and just one cheap part is required (such because the MPU-6050).

Extra information

About Bianchi Gabriele



What's your reaction?

Leave A Reply

Your email address will not be published.